0.91 Inch 128×32 Oled Lcd Display Module Ic I2c Dc 3.3v 5v For Arduino Pic
1 Channel Relay Module For Arduino
Features of 1 Channel 5 Volts Arduino Relay Module:
With isolation groove in the control area and load area.
With power and relay action indication, bright when connect and go off when disconnects.
When there is a signal in signal input, public side and the common side will break over.
It can be not only used as a microcontroller development board module but also as a home appliance control.
It can not only control the DC or AC signal but the 220V AC load.
With a permanent open and close vents contact.
It is convenient to connect with blue KF301 terminal access control cable.
Specification of Single One Channel 5V Best Arduino Relay Module:
VCC: Power interface,5V
GND: Ground
IN: Control interface.
Drive Current: At least 4mA
COM: Control circuit ground, connect to GND
Size: approx. 41 x 16 x 16mm/ 1.61 x 0.62 x 0.62''
Weight: Approx. 12g
Package Includes:
1 x 1 Channel 5V Arduino Relay Module
Best Online Shopping website for 1 Channel 5V Arduino Relay Module Single One Channel 5 Volts Relay Module For Arduino in cheap price in Karachi, Lahore, Islamabad, Rawalpindi, Sukkur, Peshawar, Multan, Quetta, Faisalabad and all over Pakistan.
1 Channel Solid State Relay Module SSR Module For Arduino
Description Additional information Reviews (0)
Description
This 5V 1 Channel SSR G3MB-202P Solid State Relay Module 240V 2A Output with Resistive Fuse is based on the Omron G3MB SSR relay which can control up to 2A at 240VAC. .This is a 1 Channel SSR Solid State Relay module which has 3 separate terminals, NO (Normal Open), COM (Common), NC (Normal Closed)
A Solid State Relay is similar to a mechanic relay where it can be controlled through a digital signal. Solid State Relay generates no noise and has a much longer lifespan in compared to the traditional mechanic relay.
When the input logic voltage is applly to the coil, the NC will disconnect from the COM breaking the conductivity between the two. At the same time, the NO will connect with the COM allowing conductivity between them. Depending on your wiring this will turn on or off the connected load.
Input parts :
DC+: connect power positive
DC-: connect power negative
CH1: relay module signal trigger point (Effective low-level trigger)
Features :
Has been assembl, and the electrical test pass.
It can be control directly by Microcontroller
Input control signal voltage:
0-2.5V status low level, relay OFF
3-5V status high level, relay ON
