30kg Servo moter TD-8130MG Waterproof Price in Pakistan

he module consists of a stepper motor driver plus a motor directly connectable to the module. The use of this module is the stepper motor connection also known as step-by-step; A stepper motor is a motor that moves in discrete steps (single step). Rotation occurs thanks to a specific sequence of impulses of constant amplitude and time applied to its inputs. 5V Stepper Motor 28BYJ-48 With Drive Test Module Board ULN2003 5 Line 4 Phase 5 Line 4 phase can be driven by ordinary uln2003 chip can also be connected in phase 2 development board used for. supporting the use of a direct plug and easy to use stepper motor used in the development board

Power supply voltage: VM = 15 V(Max). Output current: IOUT=1.2 A(ave) / 3.2 A (peak). Output low ON resistor: 0.5Ω (VM ≥ 5 V). Built-in thermal shutdown circuit and low voltage detecting circuit. Thermal Shutdown Circuit. Heat Radiation Design. Back-EMF protection.

Driver IC: PCA9685; Adjustable frequency PWM up to about 1.6 kHz; 12-bit resolution for each output – for servos, that means about 4us resolution at a 60Hz update rate; Reverse polarity protection on the terminal block input Configurable push-pull or an open-drain output; The output enable pin to quickly disable all the outputs; Terminal block for power input; Green power-good LED 3 pin connectors in groups of 4 so you can plug in 16 servos at once; Chainable design; A spot to place a big capacitor on the V+ line220-ohm series resistors on all the output lines to protect them, and to make driving LEDs trivial.; This board/chip uses an I2C 7-bit address between 0x60-0x80, selectable with jumpers Dimension:- Length: 62mm; Width: 25mm; Height: 15mm; Weight: 10gm Packaged by:- Sharvi Technologies (OPC) Pvt. Ltd.; Address:- #09, CK Nagar, AECS layout, Hosa Road, Bangalore-560100